Every air conditioner works the same basic way, from a small window unit to a 5-ton central system. Refrigerant absorbs heat inside your home, a compressor pumps it outdoors, and the heat is released outside. What changes from one type to the next is where the parts sit and how the cooled air reaches you.
That difference drives cost, efficiency, noise and how much of your home you can cool. Below are the 12 system types we sell and support every day, with a plain-English explanation of each and who it's best for.
New to how AC works? Start with What Is an AC Condenser Unit and How Does It Work? or 10 Things Every Homeowner Should Know About Their Air Conditioner.
Quick comparison
| System type | Best for | Ducts needed? | Heats too? | Upfront cost |
|---|---|---|---|---|
| Central split AC | Whole homes with existing ducts | Yes | With a furnace | High |
| Heat pump split system | Whole homes in mild-to-cold climates | Yes | Yes | High |
| Dual-fuel system | Homes with gas and cold winters | Yes | Yes | Higher |
| Packaged unit | Homes or buildings with no indoor space for equipment | Yes | Often | High |
| Ductless mini split | Homes without ducts, additions, single rooms | No | Usually | Moderate to high |
| Ducted mini split | Replacing central air with inverter efficiency | Short runs | Yes | High |
| Window AC | One room or a small apartment | No | Some models | Low |
| PTAC | Hotels, apartments, senior living | No | Yes | Moderate |
| VTAC | Hotel rooms and apartments that need a hidden unit | Short runs | Yes | Moderate |
| Portable AC | Renters, temporary cooling | No | Some models | Low |
| Geothermal | Long-term homeowners | Yes | Yes | Very high |
| Evaporative cooler | Hot, dry climates only | Optional | No | Low to moderate |
1. Central split air conditioner
The most common setup in American homes. A split system divides the equipment in two:
- Outdoor condenser: holds the compressor, condenser coil and fan. This is where heat leaves the house.
- Indoor evaporator coil: sits on top of your furnace or inside an air handler. Your furnace's blower pushes air across it and through your ductwork.
Copper refrigerant lines connect the two. Moisture pulled from the air drips off the indoor coil into a drain pan and out a condensate line.
Pros: even whole-home cooling; quiet indoors because the compressor is outside; shares ductwork and blower with your furnace.
Cons: needs ductwork in good condition; must be sized correctly for the house; installation requires a licensed technician.
Shop: Furnace & AC Systems · Goodman R-32 Air Conditioners
2. Heat pump split system
A heat pump looks just like a central AC condenser, but it has a reversing valve that lets it run the refrigerant cycle backward. In summer it moves heat out of your home; in winter it pulls heat from the outdoor air and brings it inside, even when it's cold out.
It pairs with an air handler (a blower cabinet with a coil and optional electric heat strips) instead of a furnace.
Pros: one system for heating and cooling; very efficient in mild climates like the Southeast; no gas line needed.
Cons: older or single-stage models lose heating capacity in very cold weather; backup heat strips can be expensive to run.
Learn more: What Is a Heat Pump? · Heat Pump vs Air Conditioner
Shop: Heat Pump Systems
3. Dual-fuel (hybrid) system
A dual-fuel system pairs a heat pump outdoors with a gas furnace indoors. The heat pump handles all the cooling and most of the heating. When outdoor temperatures drop below a set point, usually somewhere around 30–40°F, the thermostat switches to the furnace, which heats more cheaply and comfortably in deep cold.
Pros: lowest heating cost in many climates with cold snaps, including much of Georgia, the Carolinas and the Midwest; furnace backup means you're never without heat.
Cons: higher upfront cost than either system alone; requires a compatible thermostat and natural gas or propane.
Learn more: Understanding Hybrid Heating
4. Packaged unit
A packaged unit puts everything in one outdoor cabinet: compressor, both coils, blower and often a gas heat section or heat strips. It connects to the home's ductwork through the wall, the roof or the crawlspace.
Packaged units are common on slab homes with no attic or basement space, on manufactured homes, and as rooftop units on commercial buildings.
Pros: frees up indoor space; one unit to service; easier installation than a split system in some homes.
Cons: all components are exposed to weather; replacing one part of the system means replacing the whole cabinet.
Learn more: Rooftop HVAC Units vs Split Systems
5. Ductless mini split
A ductless mini split has an outdoor condenser connected by a small refrigerant line set to one or more wall-mounted indoor heads. Each head cools (and usually heats) its own room, with its own remote or thermostat. Only a 3-inch hole through the wall is needed.
Most mini splits are inverter-driven, meaning the compressor speeds up and slows down instead of cycling fully on and off. That makes them among the most efficient systems available.
- Single-zone: one outdoor unit, one indoor head. Good for a garage, addition or bonus room.
- Multi-zone: one outdoor unit with two to five or more indoor heads, so each room is its own zone.
- DIY models: pre-charged line sets let handy homeowners install some systems, like MrCool DIY, without vacuuming or charging refrigerant.
Indoor heads also come as ceiling cassettes and floor-mounted consoles. Consoles sit low on the wall and are a good fit under windows or in rooms with sloped ceilings.
Pros: no ductwork; room-by-room control; very high SEER2 ratings; quiet.
Cons: wall-mounted heads are visible; higher cost per room than window units; filters on each head need regular cleaning.
Learn more: Multi-Zone Mini Split Systems · MrCool DIY Mini Split Review · Mini Split Electrical Requirements
Shop: Daikin Mini Split Systems
6. Ducted mini split (central inverter system)
A ducted mini split uses the same inverter outdoor unit as a ductless system but connects to a concealed air handler that feeds ductwork. Options range from slim-duct units serving a few rooms to full central systems, such as the MrCool Hyper Heat central ducted series, that replace a conventional furnace-and-AC setup.
Pros: inverter efficiency and quiet operation with no visible indoor heads; strong cold-weather heating on hyper-heat models.
Cons: still needs ductwork; fewer installers are familiar with them than with conventional systems.
Learn more: Hyper Heat 2nd Gen vs VersaPro
7. Window air conditioner
A window unit is a complete air conditioner in one box. The cold coil faces the room; the hot coil hangs outside. It should tilt slightly toward the outside so condensation drains outdoors.
Newer U-shaped designs straddle the window sash, so the noisy half sits outdoors and you can still open the window.
Pros: least expensive way to cool a room; easy to install and remove; fine for renters.
Cons: blocks the window; louder than split systems; not practical for whole-home cooling.
Learn more: Why We Sell MrCool U-Shaped Window Units
8. PTAC (packaged terminal air conditioner)
The through-the-wall unit you see under hotel windows. A PTAC is a self-contained heating and cooling unit installed in a wall sleeve with an outdoor grille. Most include electric heat or a heat pump.
Pros: each room has its own controls; a failed unit can be swapped in minutes; no ductwork.
Cons: louder than split systems; requires a wall opening and a dedicated circuit.
Learn more: What Is a PTAC Unit? · PTAC Sizing Guide and Chart · GE Zoneline PTACs
9. VTAC (vertical terminal air conditioner)
A VTAC works like a PTAC but stands upright in a closet, pulling outdoor air through a wall louver and sending conditioned air through short ducts. It can serve more than one room and keeps the equipment out of sight.
Pros: hidden and quieter than a PTAC; can serve a bedroom and living area from one unit.
Cons: needs closet space; installation is more involved than a PTAC.
Learn more: What Is a VTAC Unit?
10. Portable air conditioner
A portable AC sits on the floor and vents hot air outdoors through a hose connected to a window kit. Like a window unit, all the parts are in one cabinet, but the whole cabinet is inside, so it's louder and less efficient. Single-hose models also pull some warm outside air into the room.
Pros: no permanent installation; can move from room to room.
Cons: the least efficient option; noisy; takes up floor space; some models need the water tank emptied.
11. Geothermal heat pump
A geothermal (ground-source) heat pump swaps the outdoor condenser for loops of pipe buried in the ground or a well. A few feet down, the earth stays at a steady temperature year-round, so the system rejects heat into the ground in summer and draws heat from it in winter.
Pros: the lowest operating cost of any system; very long-lasting underground loops; quiet, with no outdoor unit.
Cons: by far the highest installation cost because of drilling or trenching; not every lot has room for loops.
12. Evaporative cooler (swamp cooler)
An evaporative cooler doesn't use refrigerant. A fan pulls outdoor air through wet pads; as water evaporates, the air cools before it's blown into the home. Windows need to be cracked open so air can flow out.
Pros: uses a fraction of the electricity of an AC; adds moisture to very dry air.
Cons: only works in hot, dry climates like Arizona and New Mexico. In humid places like Georgia or Florida, it makes the house cooler but muggy.
Not a type, but a big difference: single-stage vs. two-stage vs. variable-speed
Any central system or heat pump can come with a different kind of compressor:
- Single-stage: runs at 100% or off. Lowest cost.
- Two-stage: runs at a low setting most of the time and switches to full power on the hottest days. Better comfort and humidity control.
- Variable-speed (inverter): adjusts in small steps to match the load. Highest efficiency, quietest operation, and the best dehumidification, which matters a lot in humid climates.
Smart thermostats and Wi-Fi controls are also available on most systems today. They help with scheduling and energy tracking, but they're a control feature rather than a separate type of air conditioner.
Learn more: Understanding Variable Capacity Heat Pumps
How to choose the right type
Start with four questions:
- Do you have ductwork in good shape? If yes, a central split AC, heat pump or dual-fuel system is usually the best value. If no, look at ductless mini splits.
- How much space are you cooling? One room calls for a window unit, PTAC or single-zone mini split. A whole house calls for a central or multi-zone system.
- What's your climate? In humid climates, prioritize two-stage or variable-speed equipment for dehumidification. In hot, dry climates, an evaporative cooler is an option. Where winters get cold, consider a dual-fuel system or a cold-climate heat pump.
- What will it cost to run, not just to buy? Compare SEER2 ratings. In the Southeast, new split-system central air conditioners must be at least 14.3 SEER2 (13.8 SEER2 for systems 45,000 BTU and larger), and higher-efficiency units often pay for themselves over their lifespan.
Size matters more than type. An oversized system short-cycles, wastes energy and leaves the house clammy; an undersized one runs nonstop and never catches up. Have a load calculation done for your home rather than copying the size of the old unit.
Learn more: HVAC Sizing Guide · What Is SEER Rating?
Frequently asked questions
What's the most efficient type of air conditioner?
Geothermal heat pumps have the lowest operating cost. Among air-source systems, inverter-driven ductless mini splits usually have the highest SEER2 ratings.
Which type is cheapest to install?
Window and portable units cost the least. For whole-home cooling, replacing an existing central system with a matched new one is usually the least expensive option, as long as the ductwork is in good shape.
Can I replace central air with a mini split?
Yes. A multi-zone ductless system or a ducted mini split can replace a conventional system, which is especially useful if your ducts are in poor shape or you want room-by-room control.
How long do air conditioners last?
Central systems and heat pumps typically last about 12–20 years with regular maintenance. Window and portable units often last 8–10 years. Geothermal ground loops can last for decades.
What refrigerant do new systems use?
New residential systems now use lower-impact refrigerants, mainly R-32 or R-454B, in place of R-410A.
Learn more: R-32 vs R-410A
Find the right system
ACUnitsForLess carries central AC systems, heat pumps, packaged units, ductless and ducted mini splits, PTACs and VTACs from Goodman, Daikin, Trane, Amana, Mitsubishi, MrCool and GE, shipped to all 48 contiguous states. Once your system is in, keep it running well with our 10 Things Every Homeowner Should Know About Their Air Conditioner.
Not sure which type fits your home? Call 678-535-7176 to talk with an HVAC specialist, or browse ACUnitsForLess.com.

